Gap and Flush Measurement of End-of-Line Vehicles

Nikon Metrology’s APDIS gap and flush measurement system can perform measurements at belt speeds of up to 140mm/s, has a large measurement volume, and uses up to three laser radar sensors for measurements around the entire vehicle. Once the vehicle is inside the system, the sensors use linear guides to move in sync with the speed of the production line, performing measurements at pre-programmed areas. Depending on production conditions, measurements with dynamic repeatability better than 0.15mm for flush measurements or 0.3mm for gap measurements are possible.

Image: Nikon Metrology Europe NV
Nikon Metrology Europe NV
www.nikonmetrology.com/de/3d-messloesungen/grosvolumige-messaufgaben-apdis-spalt-und-buendigkeitsmessung

THIS MIGHT ALSO INTEREST YOU

10MP CXP-12 Camera

10MP CXP-12 Camera

Mikrotron’s 10MP EoSens 10CCX12-FM CXP-12 camera with global shutter takes full advantage of the maximum performance of the Gsprint 4510 CMOS sensor, allowing color images to be captured at up to to 478fps.